
Lectrosonics Digital Hybrid Wireless® Micro Transmitter
A1
SKU LECTRO-SSM-A1
Available to order — allow extra processing and shipping time
Special order: non-cancelable, non-returnable
The SSM is ideal in theatrical or any other production where concealment in costuming is required. In spite of its tiny size, the transmitter offers an extensive feature set and performance on par with all of the Digital Hybrid Wireless® models.
Frequencies are selectable in 100 kHz or 25 kHz steps across a maximum tuning range of 76.7 MHz. This yields a total of 3072 available frequencies across three standard frequency blocks. The tuning range varies in other blocks to meet applicable frequency allocations.
The servo bias input accepts mic or line level signals with a wide range of gain adjustment in 1 dB steps. Accurate LED indications on the keypad allow precise gain adjustments to be made for the maximum signal to noise ratio and minimum distortion. The limiter in the preamp can cleanly handle signal peaks over 30 dB above full modulation, allowing the input gain to be set high enough to achieve the maximum signal to noise ratio, yet provide protection against input overload.
Along with providing peerless audio quality with wide frequency response and dynamic range in Nu Hybrid mode, the technology used in the SSM includes compatibility modes for Lectrosonics Mode 3 and IFB receivers.
* Digital Hybrid Wireless™ is a revolutionary new design that combines 24-bit digital audio with an analog FM radio link to provide outstanding audio quality and the extended operating range of the best analog wireless systems. The design overcomes channel noise in a dramatically new way, digitally encoding the audio bitstream in the transmitter and decoding it in the receiver, yet sending the encoded information via an analog FM wireless link. This proprietary DSP algorithm eliminates a compandor circuit and its artifacts and preserves the RF spectral footprint of analog FM designs to simplify multi-channel coordination with existing analog wireless systems.
Accessories
Features
- Tunable across 3 frequency blocks
- Digital Hybrid Wireless® audio for compandor-free digital quality
- Selectable 25 or 50 mW RF power
- Compatibility modes for use with analog receivers
- 25 or 100 kHz tuning steps
- Wide range input gain control in 1 dB steps
- Quick change Lithium-ion rechargeable battery
- Audio coupled remote control
- Tunable across a variety of frequency blocks
- Selectable 10, 25 or 50 mW RF power (varies per model; see specfications)
- 25 or 100 kHz tuning steps for up to 3072 selectable frequencies
Specifications
- Frequency Stability: ± 0.002%
- Operating temp. range: Celsius: -20° - 40°
- Band A1: 470.100 - 537.575
- Farenheit: -5° - 104°
- Band B1: 537.600 - 607.950
- SSM: Compliant with ETSI EN 300 422-1 v1.4.2
- SSM-941/E01/E02/E06/X: 60 dB below carrier
- Band B2: 563.200 - 639.975 Equivalent input
- Block 606: 606.000 - 631.500 noise: –120 dBV (A-weighted)
- Band C1: 614.400 - 691.175
- Input level: Nominal 2 mV to 300 mV, before limiting. Greater than
- Input impedance: • Mic: 300 or 4.5 k ohm; selectable
- Input limiter: DSP controlled, dual envelope “soft” limiter with
- Gain control range: 44 dB; digital control
- Band C2: 640.000 - 716.700 Modulation
- Frequency Response: 70 Hz to 20 kHz (+/-1dB)
- THD: 0.2% (typical)
- SNR at receiver output: SmartNR No Limiting w/Limiting
- Steps: Selectable; 100 kHz or 25 kHz attack and release time constants. Once activated, the limiter compresses 30+ dB
- RF Power output: SSM/E01/E01-B2/X:
- SSM/E02: 10 mW
- Controls: Side panel membrane switches with LCD interface
- SSM/E06: 50 or 100 mW EIRP for power on/off and all setup and configuration controls
- Audio Input Jack: LEMO 00 Series 3-pin
- Compatibility Modes: US: Nu Hybrid, Mode 3, IFB
- Antenna: Galvanized steel, flexible wire
- E01: Digital Hybrid, Mode 3, IFB
- E01-B2: Digital Hybrid, Mode 3, IFB
- Battery: Lithium-ion 3.6 V 1000 mAH LB50 battery pack
- E02: Digital Hybrid, Mode 3, IFB
- Battery Life: 6 hours per charge
- E06: 100 Series, 200 Series, Mode 3, Digital Hybrid,
- Weight: 2.3 ounces (65.2 grams) including lithium battery pack
- SSM/X: 100 Series, 200 Series, Mode 3, Digital Hybrid, Dimensions
- Pilot tone: 25 to 32 kHz; 3.5 kHz deviation (Nu Hybrid mode); ± 50 kHz
- SSM/E01/E01-B2/E02/E06/X: 180KF3E
Pairs well with

Lectrosonics Digital Hybrid Wireless® Micro Transmitter
