The M2T transmitter occupies a half rack space. This kit provides the hardware needed to mount one M2T into a single rack space.

Single Rack Mount Kit for M2T and DSQD Installing One M2T into a Single Rack The M2T transmitter occupies a half rack space. This kit provides the hardware needed to mount one M2T or DSQD into a single rack space. hardware that came with the units. Part numbers are included in case individual items need to be reordered. 4. Insert two (2) Cap Screws (Part #28885) through the Rack Handle (Part #27082) holes and install the Rack Handle onto the Flange Bracket through the holes in the unit’s front panel. Firmly tighten the Cap Screws using the long leg of the Hex Wrench as shown. 1. Remove the Trim Cap (Part #P1330) from both sides of the front panel of the M2T unit to be rack mounted. 2. Remove the breakaway tabs on both sides of the Chassis Cover Panel. This requires the use of a flat-blade screwdriver inserted into the slots and levering the tabs away on each side of the unit. 3. Insert the Flange Bracket (Part #27076) into the open slot in the left-front side of the Chassis Cover Panel. 5. Unless also installing a Front Mounted Antenna, insert the Hole Plug (Part #35959) into the open antenna hole in the Flange Bracket by aligning the flat sides of the plug with those of the bracket hole and pushing into place until flush. 6. Install the Front Tie Bracket (Part #25991) into the open slot in the right side of the M2T Chassis Cover Panel with the protruding nuts facing rearward, affix with two (2) Cap Screws (Part #28885) provided and firmly tighten with the Hex Wrench. See next page. (RMPM2T-1) M2T Single Rack Mount Kit.