The DNT0212 processor subscribes to channels on a Dante network and delivers them to an internal digital matrix for automatic mixing and processing, and to Dante network transmit channels. In addition, two analog line level inputs are provided for use with local sources audio sources such as voice evacuation announcements.

The outputs of the matrix can be assigned to a Dante transmit channel, an analog output and/or routed back to an input to be further mixed and processed with another input channel or matrix mix.

Accessories

Features

• 32 inputs from Dante
• 2 analog line level inputs
• 16 outputs to DanteTM transmit channels
• 8 line level analog outputs
• Support for multi-level mixing: mixes can be looped back and used as mixer inputs
• Extensive signal processing including filters, delay and channel linking for dynamic processing (compressors, limiters)
• 4 mic/line level analog outputs
• Gain smoothing to prevent transient noise during instantaneous level changes
• Supports both switched and redundant modes in DanteTM operation
• Four test signal generators available for system setup and testing
• Post-mixing signal processing on all inputs (analog and digital)
• Extensive macro command language
• 48 independent automatic mixers with 38 inputs per mixer and channel activity detectors
• Control interfaces via USB, RS-232, Ethernet and programmable logic I/O
• Rack mount or under table mount

Specifications

• Audio inputs: Filters:
• EQ stages: 4 per input channel
• Audio input channels: Internal Signal Generator:
• Digital: 32 Dante channels
• Modes: single sweep, continuous sweep
• Analog: 2 line level analog (for paging); gain -20 dB to +20
• Waveforms: sawtooth (up or
• Sweep rate: linear, logarithmic
• Max. analog input level: 20 dBu
• Parameters: start freq, stop freq,
• Dynamic range: 102 dB level [dBu], sweep
• THD + noise: 0.01% time [sec]
• A-D Sampling Rate: 48 kHz; fixed
• White noise parameter: Level [dBu]
• Pink noise parameter: Level [dBu]
• Tone (sine wave) parameters: Level [dBu], frequency
• Low Pass: Butterworth (6, 12, 18, 24 dB/octave)
• Dante Interface: Linkwitz-Riley (12, 24 dB/octave)
• Additional parameters: frequency [Hz]
• High Pass: Butterworth (6, 12, 18, 24 dB/octave)
• Supported sampling rate: 48 kHz Bessel (6, 12, 18, 24 dB/octave)
• Data rate LED: 100Mbps/1Gbps Linkwitz-Riley (12, 24 dB/octave)
• Activity LED: blinks when active
• Modes of operation: Switched mode using either connector;
• Low Shelving: Butterworth (6, 12, 18, 24 dB/octave)
• Network Connectivity: Dante interface and Ethernet control can be frequency [Hz]
• High Shelving: Butterworth (6, 12, 18, 24 dB/octave)
• Peaking EQ (parametric): Parameters:
• Compressor: Soft knee with RMS level detector eliminates
• Power Requirements: 100-240 VAC, 50/60 Hz
• Power Consumption: 20 W maximum
• Dimensions: 1.75 x 19.00 x 7.70 inches
• Weight: 5.32 lbs., 1.7 kg.